Removal Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of ECM Bolts

Courtesy of GENERAL MOTORS CORP.

Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
Remove the ECU module. Refer to Engine Control Module (ECM) Replacement .

Fig 2: View Of Generator Bolts

Courtesy of GENERAL MOTORS CORP.

Remove the generator assembly. Refer to Generator Replacement (L26) or Generator Replacement (LY7) .

Fig 3: Coolant Recovery Reservoir

Courtesy of GENERAL MOTORS CORP.

Remove the coolant overflow reservoir. Refer to Coolant Recovery Reservoir Replacement .

Fig 4: Locating Power Steering Reservoir Mounting Stud Bolt

Courtesy of GENERAL MOTORS CORP.

Remove the power steering reservoir. Refer to Remote Power Steering Fluid Reservoir Replacement .
Remove the camshaft covers.
- For the left camshaft cover, refer to Valve Rocker Arm Replacement - Left .
- For the right camshaft cover, refer to Valve Rocker Arm Replacement - Right .
Remove the upper radiator hose. Refer to Radiator Hose Replacement - Inlet (3.8L) or Radiator Hose Replacement - Inlet (3.6L) .

Fig 5: View Of Water Pump

Courtesy of GENERAL MOTORS CORP.

Remove the water pump. Refer to Water Pump Replacement (LY7) or Water Pump Replacement (RPOs L26/L32) .
Remove the engine splash shield. Refer to Splash Shield Replacement - Engine .

Fig 6: View Of Crankshaft Balancer

Courtesy of GENERAL MOTORS CORP.

Remove the crankshaft balancer. Refer to Crankshaft Balancer Replacement .
Remove the drive belt tensioner. Refer to Drive Belt Tensioner Replacement .

Fig 7: Engine Front Cover

Courtesy of GENERAL MOTORS CORP.

Remove the engine front cover from the engine block. Refer to Engine Front Cover Removal .