Front Seat Cushion Outer Trim Panel Replacement (Power)

Fig 1: Front Seat Cushion Outer Trim Panel Replacement (Power)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the front seat. Refer to Front Seat Replacement - Bucket . Remove the recliner handle. Refer to Driver Seat and Passenger Seat Recliner Handle Replacement .
1	Screw, Seat Riser Finish Cover (Qty: 4) NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)
2	Cover, Seat Riser Finish Front Tip: Pull out the front and side covers at the same time to gain access to the screw on the back side of the front corner.
3	Screw, Seat Riser Finish Cover Tighten: 2 N.m (18 lb in)
4	Cover, Seat Riser Finish Outboard Tip: Disconnect the seat switch electrical connectors. Remove the switches from the cover if replacing the cover.