LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Optra5 LS, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine Mechanical - 2.0L (L34 GMDAT) >> Repair Instructions >> Oil Pump Cleaning and Inspection >> Inspection Procedure

Inspection Procedure

    Fig 1: Rear View Of Oil Pump
    GM1252148Courtesy of GENERAL MOTORS CORP.
  1. Inspect all parts for signs of wear. Refer to Engine Mechanical Specifications .
  2. Coat all oil pump parts with clean engine oil and install.
    3. NOTE: Pack the oil pump gear cavity with petroleum jelly to ensure an oil pump prime, or engine damage could result.
    NOTE: Refer to Fastener Notice .
  3. Apply LOCTITE® 242 to the rear cover bolts and install the cover and the bolts.

    Tighten:  Tighten the rear cover bolts to 6 N.m (53 lb in)  .

  4. Install the safety relief valve, the spring, the washer, and the bolt.

    Tighten:  Tighten the safety relief valve bolt to 30 N.m (22 lb ft)  .

scientia non olet · About LEMON Manuals