Headlamps Always On - Low or High Beam
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Headlights Schematics | |||
| 1 | Did you review the Lighting System Description and Operation and perform the necessary inspections? | Go to Step 2 | Go to Exterior Lighting Systems Description and Operation |
| 2 |
|
Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 |
| 3 |
|
Go to Step 4 | Go to Step 6 |
| 4 |
|
Go to Step 8 | Go to Step 5 |
| 5 | Test the headlamp switch signal circuit for a short to ground. Refer to Circuit Testing
and to Wiring Repairs
. Did you find and repair a short to ground in the headlamp switch signal circuit? |
Go to Step 9 | Go to Step 7 |
| 6 | Repair the short to voltage in the headlamp control circuit. Refer to Circuit Testing
and to Wiring Repairs
. Did you complete the repair? |
Go to Step 9 | - |
| 7 | Replace the headlamp relay. Refer to Relay Replacement (Within an Electrical Center)
. Did you complete the replacement? |
Go to Step 9 | - |
| 8 | Replace the headlamp switch. Did you complete the replacement? |
Go to Step 9 | - |
| 9 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |