Trunk Ajar Indicator Inoperative (Convertible)
Trunk Ajar Indicator Inoperative (Convertible)
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Instrument Cluster Schematics Connector End View Reference: Displays and Gages Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 | Open the rear compartment. Is the TRUNK AJAR message displayed on the driver information center (DIC)? |
Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 |
| 3 |
|
Go to Step 8 | Go to Step 4 |
| 4 |
|
Go to Step 5 | Go to Step 6 |
| 5 | Connect a fused jumper between the trunk ajar switch signal and ground circuits. Is the trunk ajar message displayed? |
Go to Step 7 | Go to Step 10 |
| 6 | Inspect for an open or high resistance in the trunk ajar switch signal circuit. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 14 | Go to Step 9 |
| 7 | Inspect for poor connections at the harness connector of the trunk release actuator. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 14 | Go to Step 12 |
| 8 | Inspect for poor connections at the harness connector of the instrument panel cluster (IPC). Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 14 | Go to Step 11 |
| 9 | Inspect for poor connections at the harness connector of the BCM. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 14 | Go to Step 13 |
| 10 | Repair open or high resistance in the trunk ajar switch signal ground circuit. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 14 | - |
| 11 | Replace the IPC. Refer to Control Module References
for replacement, setup, and programming. Did you complete the repair? |
Go to Step 14 | - |
| 12 | Replace the trunk release actuator. Did you complete the repair? |
Go to Step 14 | - |
| 13 | Replace the BCM. Refer to Control Module References
for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 14 | - |
| 14 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 3 |