DIC Warning Messages - Roof

DIC Warning Message	Possible Cause	Solution
IMPORTANT: This diagnostic table is to be used only in conjunction with other diagnostic procedures in this section. Using this diagnostic table without being directed to its use, may result in the misdiagnoses of the power folding top system.
ATTACH TRUNK PARTITION	Luggage barrier not in place Luggage barrier switch circuitry Open luggage barrier switch	Install the luggage barrier. Repair open in the switch supply voltage circuit Repair open in the switch signal circuit Replace luggage barrier switch Replace folding top control module
CLOSE TRUNK TO MOVE TOP	Trunk ajar switch circuitry Open in the switch supply voltage circuit Open or a short to ground in the switch signal circuit Trunk ajar switch	Refer to Trunk Ajar Indicator Inoperative
SET PARK BRAKE TO MOVE TOP	Park brake switch circuitry Open in the park brake switch ground circuit Open in the park brake switch signal circuit Park brake switch	Refer to Brake Warning Indicator Inoperative
SHIFT TO PARK TO MOVE TOP	Gear shift mode switch circuitry Open in the gear shift mode switch ground circuit. Open in the park/neutral signal circuit Gear shift mode switch	Refer to Starter Solenoid Does Not Click
TOP MOTOR OVER TEMPERATURE	Internal short in the folding top pump motor Folding top pump motor temperature sensor circuitry Temperature sensor Folding top module	Refer to Diagnostic System Check - Vehicle
TOP NOT SECURE	Tonneau latch circuitry Tonneau relay Tonneau latch Top open switch Pin receiver switch 5 Bow lowered switch	Repair the short to ground in the folding top cover ajar signal circuit. Short to B+ in the control circuit of the folding top cover latch. Open in the circuitry of the pin receiver switch. Open in the circuitry of the top open switch. Refer to Folding Top Stowage Compartment Lid Release Inoperative
TOO COLD TO MOVE TOP	Folding to pump motor temperature sensor Folding top pump motor temperature sensor circuitry Folding top module	Refer to Diagnostic System Check - Vehicle
UNLATCH HEADER TO MOVE TOP	Pin receiver switch circuitry Pin receiver switch	Unlatch the header. Repair the short to voltage in the folding top connected signal circuit. Replace the pin receiver switch.