LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Control System & Fuel System - 6.6L (LLY) - Introduction (2 Of 2)) >> Repair Instructions >> Intake Air Temperature (IAT) Sensor 2 Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the air intake pipe. Refer to Air Intake Pipe Replacement .
  3. Disconnect the intake air temperature (IAT) sensor (2) electrical connector.
    4. Fig 1: View Of IAT Sensor
    GM1733089Courtesy of GENERAL MOTORS CORP.
  4. Remove the IAT sensor from the center intake manifold.
scientia non olet · About LEMON Manuals