LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2007 >> Chevy Express G2500, Van Cargo, 6.6 6 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Transfer Case - BW 4473-NP3) >> Repair Instructions - On Vehicle >> Transfer Case Output Shaft Seal Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing Rear Output Shaft Seal Using J 45756
    GM833029Courtesy of GENERAL MOTORS CORP.
  1. Using J 45756  , install a new rear output shaft seal. See Special Tools .
  2. Install the rear propeller shaft. Refer to One-Piece Propeller Shaft Replacement .
  3. Check the fluid level. Add fluid, if necessary.
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals