Special Tools

WARNING: This page is about a different variant/trim than selected.

Special Tools

Illustration	Tool Number/Description
Courtesy of GENERAL MOTORS CORP.	J 3289-20 Holding Fixture
Courtesy of GENERAL MOTORS CORP.	J 5590 Pinion Bearing Race Installer - Rear
Courtesy of GENERAL MOTORS CORP.	J 8092 Driver Handle
Courtesy of GENERAL MOTORS CORP.	J 22828 Input and Countershaft Race Installer
Courtesy of GENERAL MOTORS CORP.	J 22912-B Rear Pinion and Axle Bearing Remover
Courtesy of GENERAL MOTORS CORP.	J 23907 Slide Hammer with Bearing Adapter
Courtesy of GENERAL MOTORS CORP.	J 26941 Bushing and Bearing Remover - 3-4 inch
Courtesy of GENERAL MOTORS CORP.	J 36373 Input Sun Gear Ball Bearing Installer
Courtesy of GENERAL MOTORS CORP.	J 36825 Output Shaft Oil Seal Remover - 4WD Models Only
Courtesy of GENERAL MOTORS CORP.	J 36850 Transjel Lubricant
Courtesy of GENERAL MOTORS CORP.	J 42176 Universal Driver Handle - Non-Threaded
Courtesy of GENERAL MOTORS CORP.	J 43484 Front Output Shaft Seal Installer
Courtesy of GENERAL MOTORS CORP.	J 45358 Case Spreader
Courtesy of GENERAL MOTORS CORP.	J 45382 Transfer Case Tester
Courtesy of GENERAL MOTORS CORP.	J 45540 Tone Ring and Bearing Installer
Courtesy of GENERAL MOTORS CORP.	J 45756 Rear Output Shaft Seal Installer
Courtesy of GENERAL MOTORS CORP.	J 45758 Input Seal Installer
Courtesy of GENERAL MOTORS CORP.	J 45759 Assembly Fixture
Courtesy of GENERAL MOTORS CORP.	J 45848 Bearing Installer
Courtesy of GENERAL MOTORS CORP.	J 45849 Bearing Remover