Low Fuel Indicator Inoperative

Step	Action	Yes	No
Schematic Reference: Instrument Cluster Schematics Connector End View References: Master Electrical Component List
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Install a scan tool. Turn ON the ignition, with the engine OFF. With the scan tool, perform the Displays Test in the instrument panel cluster (IPC) Special Functions. Does the low fuel indicator illuminate?	Go to Testing for Intermittent Conditions and Poor Connections	Go to Step 3
3	Replace the IPC. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement?	Go to Step 4	-
4	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 2