Instrument Cluster Inoperative
Instrument Cluster Inoperative
| Step |
Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Instrument Cluster Schematics Connector End View References: Displays and Gages Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 |
|
Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 |
| 3 |
|
Go to Step 4 | Go to Step 7 |
| 4 | Connect a test lamp between the ignition 1 voltage circuit of the IPC and the ground circuit of the IPC. Does the test lamp illuminate? |
Go to Step 5 | Go to Step 6 |
| 5 | Inspect for poor connections at the harness connector of the IPC. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
Go to Step 9 | Go to Step 8 |
| 6 | Repair the open or the high resistance in the IPC ground circuit. Refer to Circuit Testing
and Wiring Repairs
. Did you complete the repair? |
Go to Step 9 | - |
| 7 | Repair the open, the short to ground or the high resistance in the ignition 1 voltage circuit. Refer to Circuit Testing
and Wiring Repairs
. Did you complete the repair? |
Go to Step 9 | - |
| 8 | Replace the IPC. Refer to Control Module References
for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 9 | - |
| 9 | Operate the system in order to verify the repair. Did you find and correct the condition? |
System OK | Go to Step 3 |