Change Engine Oil Indicator Always On

Step	Action	Yes	No
Schematic Reference: Instrument Cluster Schematics Connector End View References: Master Electrical Component List
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Start the engine. Does the change engine oil indicator illuminate in the instrument panel cluster (IPC)?	Go to Step 3	Go to Testing for Intermittent Conditions and Poor Connections
3	Install a scan tool. With the scan tool, observe one of the following engine oil life remaining parameters: Engine Oil Life Remaining parameter in the powertrain control module (PCM) Engine Data 2 data list - gas only. Engine Oil Life Remaining parameter in the PCM Engine Data 1 data list - 6.6L diesel only. Does the Engine Oil Life parameter display 0%?	Go to Step 4	Go to Step 5
4	Reset the engine oil life. Refer to GM Oil Life System Resetting . Does the change engine oil indicator turn off?	Go to Step 6	Go to Step 5
5	Replace the IPC. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement?	Go to Step 6	-
6	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 2