Panel Replacement - Cargo Box Bridge Center (Avalanche)

Fig 1: View Of Cargo Box Bridge Center Panel Assembly & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Ensure headlamp switch is in the OFF position. Remove rear compartment cover assembly. Refer to Cargo Box Front Cover, Center Cover, and Rear Cover Replacement .
1	Cargo Box Bridge Center Panel Screw (Qty: 6) NOTE: Refer to Fastener Notice . Tighten: 7 N.m (62 lb in)
2	Cargo Box Bridge Center Panel Retainer (Qty: 5)
3	Cargo Box Bridge Center Panel Assembly Tip: Disconnect electrical connector. When re-installing panel assembly, lubricate panel grommet prior to seating. If replacing panel assembly, transfer high mount stop lamp. Refer to High Mounted Stop Lamp Replacement (Yukon) or High Mounted Stop Lamp Replacement (Escalade) or High Mounted Stop Lamp Replacement (Avalanche) .