LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 8.1L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Replacement - Air Conditioning >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the accessory drive belt. Refer to Drive Belt Replacement - Accessory .
  2. Install a breaker bar into the air conditioning (A/C) belt tensioner adapter opening.
  3. Rotate the A/C belt tensioner clockwise in order to relieve tension on the belt.
    Fig 1: A/C Belt Tensioner
    GM370869Courtesy of GENERAL MOTORS CORP.
  4. Remove the A/C belt from the pulleys.
  5. Slowly release the tension on the A/C belt tensioner.
  6. Remove the breaker bar from the A/C belt tensioner.
  7. Clean and inspect the belt surfaces of all the pulleys.
scientia non olet · About LEMON Manuals