LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 8.1L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Intake Manifold Disassemble

Intake Manifold Disassemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Vacuum Plug
    GM1310056Courtesy of GENERAL MOTORS CORP.
  1. Remove the vacuum plug (513).
    2. Fig 2: View Of Throttle Body, Nuts, Studs & Gasket
    GM1310037Courtesy of GENERAL MOTORS CORP.
  2. Remove the throttle body nuts (503).
  3. Remove the throttle body (502) and gasket (501).
  4. Discard the gasket.
  5. Remove the throttle body studs (504), if required.
    6. Fig 3: View Of Oil Fill Tube & Components
    GM1310034Courtesy of GENERAL MOTORS CORP.
  6. Remove the oil fill cap (418).
  7. Remove the oil fill tube (416) and bolt (419).
    8. Fig 4: View Of MAP Sensor & Grommet
    GM471023Courtesy of GENERAL MOTORS CORP.
  8. Remove the bolt and manifold absolute pressure (MAP) sensor.
  9. Inspect the MAP sensor grommet for damage.
    10. Fig 5: View Of EVAP Tube
    GM471013Courtesy of GENERAL MOTORS CORP.
  10. Remove the evaporative emission (EVAP) tube.
    11. Fig 6: View Of EVAP Purge Valve & Bolt
    GM471015Courtesy of GENERAL MOTORS CORP.
  11. Remove the EVAP canister purge solenoid valve and bolt.
  12. Inspect the O-ring seal for damage. Replace as needed.
scientia non olet · About LEMON Manuals