Engine Flywheel Installation (Manual Transmission)

WARNING: This page is about a different variant/trim than selected.

Fig 1: Engine Flywheel & Bolt (Manual Transmission)

GM1198674

Courtesy of GENERAL MOTORS CORP.

Install the engine flywheel.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the engine flywheel bolts.
Tighten the fasteners following a criss-cross pattern.

Tighten:
- Tighten the engine flywheel bolts a first pass to 40 N.m (30 lb ft).
- Tighten the engine flywheel bolts a second pass to 80 N.m (59 lb ft).
- Tighten the engine flywheel bolts a final pass to 100 N.m (74 lb ft).