LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 8.1L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Cylinder Head Cleaning and Inspection >> Flatness Measurement Procedure

Flatness Measurement Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Inspecting Cylinder Head For Warpage
    GM64318Courtesy of GENERAL MOTORS CORP.
  1. Measure the cylinder head for warpage with a straight edge and feeler gage.
    • A cylinder head block deck with warpage in excess of 0.050 mm (0.002 in) within a 150.0 mm (6.0 in) area must be repaired or replaced.
    • A cylinder head exhaust manifold deck with an overall warpage in excess of 0.102 mm (0.004 in) must be repaired or replaced.
    • A cylinder head intake manifold deck with warpage in excess of 0.080 mm (0.003 in) must be repaired or replaced.
  2. A cylinder head block deck can be resurfaced up to 0.305 mm (0.012 in) maximum removal.
    3. IMPORTANT: Excessive cylinder head resurfacing will affect compression ratio and emission control.
  3. A cylinder head that requires excessive resurfacing must be replaced.
scientia non olet · About LEMON Manuals