Tools Required

J 43276  Clutch Pilot Bearing Remover

Fig 1: Removing Clutch Pilot Bearing Using J 43276
Courtesy of GENERAL MOTORS CORP.
CAUTION: Refer to SAFETY GLASSES CAUTION in Cautions and Notices.
NOTE: When using the J 43276 Clutch Pilot Bearing Remover, always secure the J 43276-1 Clutch Pilot Bearing Remover tool body using a wrench. Do not allow the J 43276-1 tool body to rotate. Failing to do so causes damage to the J 43276-1 tool body.
1. Remove the clutch pilot bearing using the J 43276  .
   1. Install the J 43276-1 tool body into the clutch pilot bearing.
   2. Using a wrench secure the J 43276-1 tool body.
   3. Insert the J 43276-2 forcing screw into the J 43276-1 tool body.
   4. Rotate the J 43276-2 forcing screw clockwise into the J 43276-1 tool body until the clutch pilot bearing is completely removed from the crankshaft.
   5. Rotate the J 43276-2 forcing screw counterclockwise to remove the J 43276-2 forcing screw from the J 43276-1 tool body.
   6. Remove the J 43276-1 tool body from the clutch pilot bearing.
2. Discard the clutch pilot bearing.