LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 8.1L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Clutch Pilot Bearing Installation

Clutch Pilot Bearing Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Clutch Pilot Bearing
    GM470617Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Safety Glasses Caution in Cautions and Notices.
  1. Install the NEW clutch pilot bearing.
    2. Fig 2: View Of Clutch Pilot Bearing Proper Installation Position
    GM1331402Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Make sure the bearing is installed parallel to the rear of the crankshaft.
  2. Measure to ensure the proper installation depth is obtained. The bearing (138) should be (a) 14.650-15.650 mm (0.577-0.616 in) from the lip of the crankshaft, or (b) 6.400-7.400 mm (0.252-0.291 in) from the crankshaft flange.
scientia non olet · About LEMON Manuals