LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 8.1L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Camshaft Removal

Camshaft Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Camshaft Retainer
    GM470998Courtesy of GENERAL MOTORS CORP.
  1. Remove the camshaft retainer bolts.
  2. Remove the camshaft retainer.
    3. Fig 2: View Of Bolts In Camshaft Front Bolt Holes
    GM471002Courtesy of GENERAL MOTORS CORP.
  3. Install three 8-1.25 x 100 mm bolts in the camshaft front bolt holes.
    4. NOTE: All camshaft journals are the same diameter, so care must be used in removing or installing the camshaft to avoid damage to the camshaft bearings.
  4. Using the bolts as a handle, carefully rotate and pull the camshaft out of the engine block.
  5. Remove the bolts from the front of the camshaft.
scientia non olet · About LEMON Manuals