LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1033 (Transfer Case - Mp 3023/3024-NQH) >> Repair Instructions - Off Vehicle >> Transfer Case Assemble >> Rear Output Shaft Assembly

Rear Output Shaft Assembly

WARNING: This page is about a different car, the 2008 GMC Sierra and 2008 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Output Shaft Assembly
GM1849367Courtesy of GENERAL MOTORS CORP.
Rear Output Shaft Assembly

Callout Component Name
1 Transfer Case Front Output Shaft Drive Sprocket Spacer - Front
2 Transfer Case Four Wheel Drive Clutch Housing
3 Transfer Case Front Output Shaft Drive Sprocket
4 Transfer Case Four Wheel Drive Clutch Housing Retaining Ring
5 Transfer Case Front Output Shaft Drive Sprocket Spacer - Rear
6 Transfer Case Front Output Shaft Drive Sprocket Retaining Ring
7 Transfer Case Oil Pump Assembly
8 Transfer Case Rear Output Shaft Speed Reluctor Wheel
9 Transfer Case Rear Output Shaft Rear Bearing Retaining Ring
10 Transfer Case Rear Output Shaft Rear Bearing Assembly
Tip: 
  • Use an arbor press or suitable installer to install the bearing to the rear output shaft.
  • Ensure the retaining ring groove in the outer race is positioned toward the rear.
11 Transfer Case Rear Output Shaft Rear Bearing Retaining Ring
scientia non olet · About LEMON Manuals