LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 2.4L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Drive Belt Tensioner And Special Tool
    GM854300Courtesy of GENERAL MOTORS CORP.
  1. Remove the front fender liner. Refer to Front Fender Liner Replacement .
  2. Install the J 44811  to the drive belt tensioner.
  3. Using the J 44811  , rotate the tensioner counterclockwise in order to release the tensioner from the drive belt.
    4. Fig 2: View Of Drive Belt
    GM1571093Courtesy of GENERAL MOTORS CORP.
  4. Remove the drive belt.
  5. Slowly rotate the J 44811  and the tensioner clockwise in order to allow the tensioner to rest.
  6. Remove the J 44811  from the drive belt tensioner.
scientia non olet · About LEMON Manuals