LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 2.4L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Drive Belt Routing 2.4L
    GM1571093Courtesy of GENERAL MOTORS CORP.
  1. Install and position the drive belt around all of the pulleys except for the drive belt tensioner.
  2. Install the J 44811  to the drive belt tensioner.
  3. Using the J 44811  , rotate the tensioner counterclockwise.
  4. Position the drive belt under the tensioner pulley.
    5. Fig 2: View Of Drive Belt Tensioner And Special Tool
    GM854300Courtesy of GENERAL MOTORS CORP.
  5. Using the J 44811  , rotate the tensioner clockwise in order to seat the tensioner pulley onto the drive belt.
  6. Install the front fender liner. Refer to Front Fender Liner Replacement .
scientia non olet · About LEMON Manuals