LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Upper Intake Manifold Sight Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Upper Intake Manifold Sight Shield
    GM1657261Courtesy of GENERAL MOTORS CORP.
  1. Install the intake manifold sight shield.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the intake manifold sight shield screws.

    Tighten:  Tighten the screws to 9 N.m (80 lb in).

scientia non olet · About LEMON Manuals