LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Supercharger Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Supercharger & Gasket
    GM1339285Courtesy of GENERAL MOTORS CORP.
  1. Install the supercharger gasket.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the supercharger and bolts.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

  3. Install the intercooler fill neck bracket bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  4. Connect the vacuum brake booster hose.
  5. Install the SCIP sensor and bolt.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    6. Fig 2: View Of Throttle Body & Gasket
    GM1339289Courtesy of GENERAL MOTORS CORP.
  6. Install the throttle body. Refer to Throttle Body Assembly Replacement in Engine Controls - 2.0L.
scientia non olet · About LEMON Manuals