LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Oil Cooler Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Drain the charged air cooling system. Refer to Draining and Filling Cooling System - Charge Air Cooling System in Engine Cooling.
    2. Fig 1: Identifying Oil Pressure Sensor, Cooler Hoses, Cooler Stud And Cooler Bolts
    GM1577505Courtesy of GENERAL MOTORS CORP.
  2. Remove the oil pressure sensor (1).
  3. Disconnect the oil cooler hoses (2).
  4. Remove the oil cooler stud (3) and the oil cooler bolts (4).
  5. Remove the oil cooler.
scientia non olet · About LEMON Manuals