LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Engine Mount To Intermediate Bracket Bolts
    GM1546774Courtesy of GENERAL MOTORS CORP.
  1. Place the engine mount onto the midrail and hand start the nuts.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Tighten the engine mount to midrail nuts (4).

    Tighten:  Tighten the nuts to 100 N.m (74 lb ft).

    3. IMPORTANT: The engine mount to intermediate bracket bolts must be hand started. Do not pry the engine mount to align the holes.
  3. Hand start the engine mount to intermediate bracket bolts.
    4. IMPORTANT: The engine mount bracket bolts must be torqued in a mandatory torque sequence as shown.
  4. Tighten the engine mount to intermediate bracket bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  5. Remove the hydraulic floor jack.
scientia non olet · About LEMON Manuals