LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Flywheel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Flywheel & Retaining Bolts
    GM412117Courtesy of GENERAL MOTORS CORP.
  1. Position the flywheel on the crankshaft as previously noted.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the flywheel bolts.

    Tighten:  Tighten the flywheel bolts to 53 N.m (39 lb ft) plus 25 degrees.

  3. Install the transmission. Refer to Transmission Replacement in Manual Transmission - MU3.
scientia non olet · About LEMON Manuals