LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Oil Cooler Installation

Oil Cooler Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Oil Cooler & Components
    GM1339280Courtesy of GENERAL MOTORS CORP.
  1. Install NEW O-rings on the oil bypass tube.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the oil bypass tube.

    Tighten:  Tighten the tube to 22 N.m (16 lb ft).

  3. Install the oil cooler.
  4. Install the oil cooler bolts.

    Tighten:  Tighten the oil cooler bolts to 16 N.m (12 lb ft).

  5. Install the oil pressure sensor.

    Tighten:  Tighten the oil pressure sensor to 18 N.m (13 lb ft).

  6. Install the oil cooler lines.
scientia non olet · About LEMON Manuals