LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Engine Front Cover and Oil Pump Installation

Engine Front Cover and Oil Pump Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Engine Front Cover
    GM412537Courtesy of GENERAL MOTORS CORP.
  1. Install the engine front cover with a new gasket.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the long water pump bolt.

    Tighten:  Tighten the water pump bolt to 25 N.m (18 lb ft).

    3. Fig 2: View Of Engine Front Cover Bolts
    GM412538Courtesy of GENERAL MOTORS CORP.
  3. Install the engine front cover bolts.

    Tighten:  Tighten the engine front cover bolts to 25 N.m (18 lb ft).

    4. Fig 3: View Of Bracket & Lift Hook Assembly
    GM1381544Courtesy of GENERAL MOTORS CORP.
  4. Install the generator bracket and lift hook assembly.
  5. Install the generator bracket and lift hook assembly bolts.

    Tighten:  Tighten the bolts to 42 N.m (31 lb ft).

    6. Fig 4: View Of Idler Pulley
    GM1381542Courtesy of GENERAL MOTORS CORP.
  6. Install the idler pulley.
  7. Install the idler pulley bolts.

    Tighten:  Tighten the pulley bolts to 22 N.m (16 lb ft).

    8. Fig 5: Identifying Drive Belt Tensioner
    GM1381540Courtesy of GENERAL MOTORS CORP.
  8. Install the accessory drive belt tensioner.
  9. Install the accessory drive belt tensioner bolts.

    Tighten:  Tighten the accessory drive belt tensioner bolts to 32 N.m (24 lb ft).

scientia non olet · About LEMON Manuals