LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Engine Flywheel Installation >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Flywheel & Retaining Bolts
    GM412117Courtesy of GENERAL MOTORS CORP.
  1. Install the flywheel.
  2. Install the new bolts.
    3. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Holding the crankshaft damper with the J 38122-A  , tighten the bolts evenly. See Special Tools .

    Tighten:  Using the J 45059  , tighten the bolts to 53 N.m (39 lb ft), plus 25 degrees.

scientia non olet · About LEMON Manuals