LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.0L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Crankshaft Rear Oil Seal Installation >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing Crankshaft Rear Oil Seal
    GM412495Courtesy of GENERAL MOTORS CORP.
  1. Remove excess sealer from seal recess.
  2. Lubricate the outside diameter of the new crankshaft seal with clean engine oil.
  3. Using the J 42067  , press the new crankshaft seal into the housing. The J 42067  also establishes the depth of the seal in the crankshaft seal bore. See Special Tools .
scientia non olet · About LEMON Manuals