LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
Fig 1: View Of Camshaft Position Sensor Housing
GM1534962Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  2. Remove the drive belt tensioner. Refer to DRIVE BELT TENSIONER REPLACEMENT - SUPERCHARGER .
  3. Remove the underhood junction block. Refer to Underhood Electrical Center or Junction Block Bracket Replacement in Wiring Systems.
  4. Disconnect the electrical connector from the camshaft position (CMP) sensor.
  5. Remove the CMP sensor studs.
  6. Remove the CMP sensor.
scientia non olet · About LEMON Manuals