Rear Bumper Impact Bar Replacement

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Bumper Impact Bar

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the rear bumper fascia. Refer to Rear Bumper Fascia Replacement (Sedan) or Rear Bumper Fascia Replacement (Coupe) .
1	Rear Bumper Impact Bar Bolt (Qty: 8) NOTE: Refer to Fastener Notice . Tip: The energy absorber is attached to the fascia. Tighten: 25 N.m (18 lb ft)
2	Rear Bumper Impact Bar