Rear Bumper Fascia Replacement (Coupe)

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Bumper Fascia (Coupe)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the tail lamps and side marker lamps. Refer to Tail Lamp Replacement (Chevy Coupe) or Tail Lamp Replacement (Chevy Pontiac Sedan) or Tail Lamp Replacement (Chevy Export) . Remove the license lamp. Refer to Rear License Lamp Replacement (Chevrolet) or Rear License Lamp Replacement (Pontiac G5) . Remove the rear wheel liners. Refer to Rear Wheelhouse Panel Liner Replacement .
1	Rear Bumper Fascia - Upper Retainers (Qty: 4)
2	Rear Bumper Fascia Tail Lamp Pocket Screws (Qty: 4) NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)
3	Rear Bumper Fascia (Inside wheel well) Bolts (Qty: 2) Tighten: 2.5 N.m (22 lb in)
4	Rear Bumper Fascia Retainers (Qty: 4)
5	Rear Bumper Fascia Tip: Pull the sides of the rear fascia at the quarter panel to release the fascia from the brackets.