LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 646 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Rear Compartment Lid Hinge Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Compartment Hinge Bolts
    GM1549897Courtesy of GENERAL MOTORS CORP.
  1. Position the rear compartment lid hinge (3) to the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the rear compartment hinge nuts (1) to the studs on the decklid.

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

  3. Install the rear compartent hinge bolts (2) to the hinge.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  4. Adjust the rear compartment lid if necessary. Refer to Rear Compartment Lid Adjustment .
scientia non olet · About LEMON Manuals