LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 642 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Column Jacket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: The column shaft splines must be free of dirt and debris.
  1. Clean the column shaft splines.
  2. Use the supplied grease to apply 2 grams (0.07 oz) of grease to the column shaft splines.
    3. Fig 1: View Of Upper Jacket
    GM854910Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the new jacket on the steering column.

    Tighten:  Tighten the bolts to 11 N.m (97 lb in).

    4. Fig 2: View Of Steering Column
    GM854962Courtesy of GENERAL MOTORS CORP.
  4. Install the steering column mounting bolts.

    Tighten: 

    1. Tighten the RH bolt to 25 N.m (18 lb ft).
    2. Tighten the LH bolt to 25 N.m (18 lb ft).

  5. Install the steering column filler. Refer to Steering Column Opening Filler Replacement .
  6. Install the ignition lock cylinder case. Refer to Ignition Lock Cylinder Case Replacement .
  7. Install the SIR coil module assembly. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement .
  8. Install the column trim covers. Refer to Steering Column Trim Covers Replacement .
  9. Install the steering wheel. Refer to Steering Wheel Replacement .
  10. Road test the vehicle to verify steering operation.
scientia non olet · About LEMON Manuals