LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 637 (Interior Trim And Paneling) >> Repair Instructions >> Pressure Relief Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Pressure Relief Valve
    GM318859Courtesy of GENERAL MOTORS CORP.
  1. Install the pressure relief valve to the lower quarter panel.
  2. Press the pressure relief valve into the quarter lower panel until the retainers lock into place at the upper and lower locations.
  3. Pull back the rear compartment trim panel.
  4. Install the rear bumper fascia. Refer to REAR BUMPER FASCIA REPLACEMENT (SEDAN) or REAR BUMPER FASCIA REPLACEMENT (COUPE) .
  5. Close the rear compartment.
scientia non olet · About LEMON Manuals