LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 636 (Instrument Panel Trim And Console Trim) >> Repair Instructions >> Instrument Panel Upper Trim Panel Replacement

Instrument Panel Upper Trim Panel Replacement

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Trim Panel Replacement - Instrument Panel (I/P) Upper
GM1539459Courtesy of GENERAL MOTORS CORP.
Instrument Panel Upper Trim Panel Replacement

Callout Component Name

Preliminary Procedures

  1. Disable the SIR system.
  2. Remove the instrument panel (I/P) trim plates. Refer to the following procedures:
  3. Remove the I/P cluster bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
  4. Tip: 

    Squeeze the upper and lower tabs of the hazard warning switch together. Remove the hazard warning switch from the I/P top panel.

    Remove the passenger inflatable restraint module. Refer to Inflatable Restraint Instrument Panel Module Replacement .

  5. Remove the I/P upper trim pad air grille assembly. Refer to Defroster Grille Replacement .
1 Instrument Panel Trim Pad Screw (Qty: 12)
NOTE: Refer to Fastener Notice .

Tighten:  2.2 N.m (19 lb in)
2 Instrument Panel Trim Pad Assembly
Tip:  Lift up to release the I/P top panel from the I/P retainer.
scientia non olet · About LEMON Manuals