Instrument Panel Retainer Replacement

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Instrument Panel (I/P) Retainer Replacement

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Disable the SIR system. Refer to SIR Disabling and Enabling . Remove the floor console. Refer to Front Floor Console Replacement . Remove the instrument panel (I/P) compartment. Refer to Instrument Panel Compartment Replacement . Remove the I/P upper trim pad. Refer to Instrument Panel Upper Trim Panel Replacement . Lower the steering column. Refer to Steering Column Replacement .
1	Instrument Panel Retainer Assembly Tip: Remove the HVAC air ducts.
2	Instrument Panel Retainer Bolt (Qty: 4) NOTE: Refer to Fastener Notice . Tighten: 9 N.m (80 lb in)
3	Instrument Panel Retainer Screw (Qty: 17) Tighten: 2.2 N.m (20 lb in)
4	Instrument Panel Retainer Nut (Qty: 8) Tighten: 25 N.m (18 lb ft)