Seat Cushion Cover and Pad Replacement - Front

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Seat Cushion Cover and Pad -- Front

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedures Remove the front seat. Refer to Front Seat Replacement - Bucket . Remove the seat cushion frame. Refer to Front Seat Cushion Frame Replacement . Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Passenger Presence System Programming and Setup .
1	Cover, Seat Cushion Tip: Disconnect the seat cushion cover J-channel from the seat cushion frame. Disconnect the electrical connectors.
2	Pad, Seat Cushion Tip: The inflatable restraint passenger presence system is part of the seat cushion pad on the passenger seat, and must be replaced as an assembly.

Callout

Component Name

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedures

Remove the front seat. Refer to Front Seat Replacement - Bucket .
Remove the seat cushion frame. Refer to Front Seat Cushion Frame Replacement .
Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Passenger Presence System Programming and Setup .

Cover, Seat Cushion
Tip:

Disconnect the seat cushion cover J-channel from the seat cushion frame.
Disconnect the electrical connectors.

Pad, Seat Cushion
Tip: The inflatable restraint passenger presence system is part of the seat cushion pad on the passenger seat, and must be replaced as an assembly.