LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 635 (Seat Hardware, Seat Trim, And Upholstery) >> Repair Instructions >> Front Seat Cushion Frame Replacement

Front Seat Cushion Frame Replacement

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Front Seat Cushion Frame
GM1538064Courtesy of GENERAL MOTORS CORP.
Front Seat Cushion Frame Replacement

Callout Component Name
NOTE: Refer to Fastener Notice .
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .

Preliminary Procedures

  1. Remove the front seat. Refer to Front Seat Replacement - Bucket .
  2. Remove the seat cushion inner trim cover. Refer to Seat Cushion Inner Trim Panel Replacement .
  3. Remove the seat cushion outer trim cover. Refer to Seat Cushion Outer Trim Panel Replacement - Front Seat .
  4. Remove the front seat cushion cover and pad. Refer to Seat Cushion Cover and Pad Replacement - Front .
  5. Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Passenger Presence System Programming and Setup .
1 Screw, Seat Cushion Assembly (Qty: 4)

Tighten:  25 N.m (18 lb ft)
2 Frame Assembly, Seat Cushion
Tip: 
  • Remove the lumbar adjuster screws.
  • Disconnect the cushion heater electrical connector.
scientia non olet · About LEMON Manuals