High Beam Indicator Inoperative

Step	Action	Yes	No
Schematic Reference: Headlights/Daytime Running Lights (DRL) Schematics (Domestic) or Headlights/Daytime Running Lights (DRL) Schematics (Export) Connector End View Reference: Master Electrical Component List in Wiring Systems.
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2	Place the headlamp switch in the HEAD position. Place the headlamp dimmer switch in the high beam position. Does the high beam indicator illuminate?	Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems	Go to Step 3
3	Do the high beam headlamps illuminate?	Go to Step 4	Go to Headlamps Inoperative - High Beams (Domestic) or Headlamps Inoperative - High Beams (Export)
4	Disconnect the instrument panel cluster connector. Probe the headlamp high beam supply voltage circuit of the instrument panel cluster (IPC) connector with a test lamp that is connected to ground. Did the test lamp illuminate?	Go to Step 6	Go to Step 5
5	Repair a open or high resistance in the headlamp high beam supply voltage circuit of the instrument panel cluster. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you complete the repair?	Go to Step 7	-
6	Replace the IPC. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement and the set up procedure?	Go to Step 7	-
7	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 2