Low Oil Pressure/Low Fuel Chime Inoperative
Low Oil Pressure/Low Fuel Chime Inoperative
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Audible Warnings Schematics | |||
| 1 | Did you review the operation and perform the necessary inspections? | Go to Step 2 | Go to Symptoms - Instrument Panel, Gages and Console |
| 2 | Inspect for poor connections at the harness connector of the instrument panel cluster (IPC) connector C1. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 6 | Go to Step 3 |
| 3 | Inspect for poor connections at the harness connector of the body control module (BCM) connector C2. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 6 | Go to Step 4 |
| 4 | Test the chime request signal circuit of the IPC for a high resistance, an open, and a short to B+. Refer to Circuit Testing
andWiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 6 | Go to Step 5 |
| 5 | Replace the BCM. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 6 | - |
| 6 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |