Chime Always On
Chime Always On
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Audible Warnings Schematics | |||
| 1 | Did you review the operation and perform the necessary inspections? | Go to Step 2 | Go to Symptoms - Instrument Panel, Gages and Console |
| 2 | Are the rear parking assist (RPA) indicators ON? | Go to Rear Parking Assist Malfunction in Rear Parking Assist | Go to Step 3 |
| 3 | Are any other indicators illuminated? | Go to Symptoms - Instrument Panel, Gages and Console | Go to Step 4 |
| 4 | Test the control circuit of the instrument panel (I/P) body control module (BCM) chime request for a short to ground. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 15 | Go to Step 5 |
| 5 |
|
Go to Step 6 | Go to Step 7 |
| 6 |
|
Go to Step 8 | Go to Step 13 |
| 7 | Test the control circuit of the headlamp and I/P lamp dimmer switch for an open. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 15 | Go to Step 12 |
| 8 |
|
Go to Step 11 | Go to Step 14 |
| 9 | Inspect for poor connections at the harness connector of the headlamp and I/P lamp dimmer switch. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 15 | Go to Step 12 |
| 10 | Inspect for poor connections at the harness connector of the BCM connector C2. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 15 | Go to Step 13 |
| 11 | Repair a short to ground in the control circuit of the ignition key alarm switch. Refer to Wiring Repairs
in Wiring Systems. Did you complete the repair? |
Go to Step 15 | - |
| 12 | Replace the headlamp and I/P lamp dimmer switch. Refer to Headlamp Switch Replacement
in Lighting Systems. Did you complete the replacement? |
Go to Step 15 | - |
| 13 | Replace the BCM. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 15 | - |
| 14 | Replace the ignition key alarm switch. Refer to Ignition Switch Replacement
in Steering Wheel and Column. Did you complete the replacement? |
Go to Step 15 | - |
| 15 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |