LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Venture LT >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Diagnostic Information And Procedures >> Change Engine Oil Indicator Always On

Change Engine Oil Indicator Always On

Change Engine Oil Indicator Always On

Step Action Yes No
Schematic Reference: Instrument Cluster Schematics 
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2
  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. With a scan tool, observe the engine oil life percent in the PCM IPC data list.
Does the scan tool display zero percent with the change engine oil message on?		 Go to Step 3  Go to Step 4 
3 Reset GM engine oil life system. Refer to GM Oil Life System - Resetting in Maintenance and Lubrication.
Has the GM engine oil life system been reset?		 Go to Step 5  -
4 Replace the instrument panel cluster (IPC). Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.
Did you complete the replacement?		 Go to Step 5  -
5
  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. With a scan tool, observe the Engine Oil Life percent in PCM IPC data list.
Does the scan tool display 100 percent with the engine oil message off?		 System OK Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
scientia non olet · About LEMON Manuals