Content Theft Deterrent (CTD) Does Not Disarm with Key Lock
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Theft Deterrent System Schematics Connector End View Reference: Theft Deterrent System Connector End Views DEFINITION: The content theft deterrent (CTD) alarm does not disarm when using a key in any door or rear compartment lock cylinder. |
|||
| 1 | Did you perform the Theft Deterrent Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - Theft Deterrent |
| 2 |
|
Go to Step 6 | Go to Step 3 |
| 3 | With the test light still connected, unlock the inoperative lock tamper switch with a key. Does the test light illuminate? |
Go to Step 8 | Go to Step 4 |
| 4 |
|
Go to Step 11 | Go to Step 5 |
| 5 | Test for an open in the door lock tamper switch signal circuit. Refer to Testing for Continuity
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 11 | Go to Step 7 |
| 6 | Test for a short to ground in the inoperative lock tamper switch circuit. Refer to Testing for Short to Ground
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 11 | Go to Step 7 |
| 7 | Test for a poor connection at the inoperative door lock tamper switch. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 11 | Go to Step 9 |
| 8 | Test for a poor connection at the RCDLR. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 11 | Go to Step 10 |
| 9 | Replace the inoperative lock tamper switch. Refer to Lock Replacement - Front Door
in Door or Lock Cylinder Replacement - Rear Compartment Lid
in Body Rear End. Did you complete the replacement? |
Go to Step 11 | - |
| 10 |
IMPORTANT:
Perform the program procedure for the ISU. Replace the RCDLR. Refer to Remote Control Door Lock Receiver Replacement
in Keyless Entry.Did you complete the replacement? |
Go to Step 11 | - |
| 11 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |