LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 958 (Engine Mechanical - 3.6L - Repair Instructions - Off Vehicle (2 Of 3)) >> Repair Instructions - Off Vehicle (2 Of 3) >> Intake Manifold Disassemble >> Upper to Lower Intake Manifold Disassemble Procedure

Upper to Lower Intake Manifold Disassemble Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Upper - To - Lower Intake Manifold Bolts
    GM1849008Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not reuse the upper-to-lower intake manifold gasket and the intake manifold-to-cylinder head sealing gaskets.
  1. Remove the upper-to-lower intake manifold bolts.
    2. Fig 2: Identifying Fuel Rail Feed Hose Bracket Bolt
    GM1849010Courtesy of GENERAL MOTORS CORP.
  2. Remove the fuel rail feed hose bracket bolt from the upper intake manifold.
    3. Fig 3: Identifying Fuel Injector Wiring Harness Bracket Bolt
    GM1849012Courtesy of GENERAL MOTORS CORP.
  3. Remove the fuel injector wiring harness bracket bolt from the upper intake manifold.
    4. Fig 4: View Of Upper & Lower Intake Manifold
    GM1849015Courtesy of GENERAL MOTORS CORP.
  4. Remove the upper intake manifold from the lower intake manifold.
    5. Fig 5: Identifying Upper -To-Lower Intake Manifold Gaskets
    GM1849016Courtesy of GENERAL MOTORS CORP.
  5. Remove and discard the upper-to-lower intake manifold gaskets.
scientia non olet · About LEMON Manuals