Upper Intake Manifold Disassemble Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Fuel Rail Support Bracket Bolt

Courtesy of GENERAL MOTORS CORP.

Remove the fuel rail support bracket bolt.

Fig 2: Identifying Fuel Rail Support Bracket

Courtesy of GENERAL MOTORS CORP.

Remove the fuel rail support bracket.

Fig 3: Identifying Manifold Absolute Pressure (MAP) Sensor Bolt

Courtesy of GENERAL MOTORS CORP.

Remove the manifold absolute pressure (MAP) sensor bolt.

Fig 4: Identifying MAP Sensor

Courtesy of GENERAL MOTORS CORP.

Remove the MAP sensor.

Fig 5: Identifying Throttle Body Bolts

Courtesy of GENERAL MOTORS CORP.

Remove the throttle body bolts.

Fig 6: Identifying Throttle Body

Courtesy of GENERAL MOTORS CORP.

Remove the throttle body.

Fig 7: Identifying Throttle Body Gasket

Courtesy of GENERAL MOTORS CORP.

Remove and discard the throttle body gasket.

Fig 8: Identifying Intake Manifold Tuning Valve Bolts

Courtesy of GENERAL MOTORS CORP.

Remove the intake manifold tuning valve bolts.

Fig 9: Identifying Intake Manifold Tuning Valve

Courtesy of GENERAL MOTORS CORP.

Remove the intake manifold tuning valve.

Fig 10: Identifying Intake Manifold Tuning Valve O-Ring

Courtesy of GENERAL MOTORS CORP.

Remove and discard the intake manifold tuning valve O-ring.

Fig 11: Identifying Fuel Injector Sight Shield Ballstud

Courtesy of GENERAL MOTORS CORP.

Remove the fuel injector sight shield ballstud.