LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 958 (Engine Mechanical - 3.6L - Repair Instructions - Off Vehicle (2 Of 3)) >> Repair Instructions - Off Vehicle (2 Of 3) >> Intake Manifold Assemble >> Lower Intake Manifold Assemble Procedure

Lower Intake Manifold Assemble Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Upper -To-Lower Intake Manifold Alignment Pins
    GM1832176Courtesy of GENERAL MOTORS CORP.
  1. Install the upper-to-lower intake manifold alignment pins.
    2. Fig 2: View Of Fuel Injector Rail
    GM1849037Courtesy of GENERAL MOTORS CORP.
  2. Install the fuel injector rail.
    3. Fig 3: Identifying Fuel Injector Rail Bolts
    GM1849033Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  3. Install the fuel injector rail bolts and tighten to 10 N.m (89 lb in).
    4. Fig 4: Identifying Fuel Injector Wiring Harness
    GM1849041Courtesy of GENERAL MOTORS CORP.
  4. Install the fuel injector wiring harness connector.
scientia non olet · About LEMON Manuals